Operational Step 1

Tell the system which products you run and how they differ.

Map the specifications that drive changeover work — materials, tooling, temperatures, weights — for each product you run. ProChangeover uses that matrix to generate the right task list automatically whenever you switch between them. No more relying on whoever wrote the last paper sheet.

Product specifications

SKU	Material	Temp (°C)	Mould
SKU-A100	HDPE	180	#42
SKU-B200	ABS	220	#78
SKU-C310	PP	195	#42
SKU-D450	Nylon	240	#91

Switching SKU-A100 → SKU-B200 generates 6 tasks automatically

Operational Step 2

Every operator sees exactly what to do next — in order, on any device.

When a changeover starts, your team gets one shared live checklist. Each task shows the spec to hit, in the sequence it needs to happen. Completed steps are visible to everyone. No parallel paper sheets, no version confusion, no supervisor needing to walk the line to find out where things stand.

Changeover Tasks

0 / 5

Product 1 Product 2

1. Clean conveyor belt surface

2. Set temperature to 180 °C

3. Replace mould #42 with #78

4. Adjust pressure to 3.5 bar

5. Verify alignment markers

Operational Step 3

After the run, see the Gantt. Find the delay. Fix the standard.

Every completed changeover produces a timestamped Gantt timeline. You can see which tasks ran to standard, which ran long, and where the overlap was missing. When a step shows up red — like a pressure adjustment that took twice as long as planned — you have the data to update the standard and close the gap on the next run.

Timeline

100%

Cleaning

Settings

Tooling

Inspection

08:00

08:05

08:10

08:15

08:20

Belt

Nozzles

Temp

⚠ +4 min over target

Pressure

Speed

Mould swap

QC Check

Completed

Issue found

20 min total

One line. One week. See if it changes anything.

Most teams are up and running within a day. Start with your highest-frequency changeover on one line. Once you have one run logged and a timeline to look at, you'll know whether this works for your operation — before you roll it out further.

1 Start with one line Pick your highest-frequency changeover

2 Up in under a day Configure, invite your team, run it

3 See the Gantt after run 1 Decide if it works before rolling out

Run your first standardized changeover this week.

Set up in 10 minutes. Invite your shift team. After the first run you'll have a Gantt timeline and a baseline time you didn't have before.

Timestamped sign-off record

Audit-ready from run one

Gantt timeline of every task

See exactly where time was lost

A repeatable standard

Not dependent on whoever showed up today

7-day free trial · Self-serve setup · No IT project required

SMED Changeover Software for Manufacturers

Tell the system which products you run and how they differ.

Every operator sees exactly what to do next — in order, on any device.

After the run, see the Gantt. Find the delay. Fix the standard.

One line. One week. See if it changes anything.

One plan. Full platform.

Run your first standardized changeover this week.

Rolling this out to a team? We'll help you do it properly.